Customer Service:
Mon - Fri: 8:30 am - 6 pm EST

 Most recent

ASTM B988-18(2022)

Standard Specification for Powder Metallurgy (PM) Titanium and Titanium Alloy Structural Components

1.1This specification covers powder metallurgy (PM) structural components fabricated from:

1.1.1Commercially pure (CP) (that is, unalloyed) titanium powder,

1.1.2Pre-alloyed powders.

1.1.3Mixtures of elemental powders or mixtures of elemental powders and pre-alloyed powders.

1.2This specification covers:

1.2.1Grade 1 PM - Unalloyed titanium,

1.2.2Grade 2 PM - Unalloyed titanium,

1.2.3Grade 3 PM - Unalloyed titanium,

1.2.4Grade 4 PM - Unalloyed titanium,

1.2.5Grade 5 PM - Titanium alloy (6 % aluminum, 4 % vanadium),

1.2.6Grade 9 PM - Titanium alloy (3 % aluminum, 2.5 % vanadium),

1.2.7Ti-6Al-4V PM Low Interstitial (LI),

1.2.8Ti-6Al-6V-2Sn PM.

1.3The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Content Provider
ASTM International [ASTM]


ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS