Customer Service:
Mon - Fri: 8:30 am - 6 pm EST

 Most recent

ASTM C1737-22

Standard Guide for Evaluating Temperature Effects to Aerosol Foam Sealant During and After Dispensing

1.1This guide covers the general effects of temperature from the aerosol foam sealant (either polyurethane or latex types) under the use temperatures.

1.2The guide is intended to estimate the observed product dispensing characteristics and foam quality of aerosol foam dispensed or cured, or both, at specific temperatures and standard conditions.

1.3Such foam sealants are primarily intended to reduce air movement in and out of building enclosures.

1.4Currently two main foam sealant types are applicable to this standard: single component polyurethane and latex.

1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6There are no other known test methods specific for measuring the product temperature range for aerosol foam sealant.

1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Content Provider
ASTM International [ASTM]


ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS