Customer Service:
Mon - Fri: 8:30 am - 6 pm EST

 Most recent

ISO 21420:2020

Protective gloves - General requirements and test methods

This document specifies the general requirements and relevant test procedures for glove design and construction, innocuousness, comfort and efficiency, as well as the marking and information supplied by the manufacturer applicable to all protective gloves.

It can also apply to arm protectors and gloves permanently incorporated in containment enclosures.

Gloves and hand protectors such as mittens, pot holders and arm protection are covered by this document.

This document does not address the protective properties of gloves and therefore is not used alone but only in combination with the appropriate specific standard(s). A non-exhaustive list of these standards is given in the Bibliography.

Content Provider
International Organization for Standardization [ISO]

Others Also Bought

BS EN ISO 15223-1:2012
Medical devices. Symbols to be used with medical device labels, labelling and information to be supplied. General ...
ANSI/ASA S2.73-2013/ISO 10819:2013 (R2019)
Mechanical vibration and shock - Hand-arm vibration - Measurement and evaluation of the vibration transmissibility ...
ISO 23388:2018
Protective gloves against mechanical risks

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.