Customer Service:
Mon - Fri: 8:30 am - 6 pm EST

 Historical

SAE AMS-H-6875B-2010 (SAE AMS-H-6875B-2010)

Heat Treatment of Steel Raw Materials

This specification covers the requirements for heat-treatment of four classes of steel and the requirements for furnace equipment, test procedures and information for heat-treating procedures, heat-treating temperatures and material test procedures. This specification is applicable only to the heat treatment of raw material; it does not cover the requirements for the heat treatment of steel parts. This specification also describes procedures that, when followed, will produce the desired properties and material qualities within the limitations of the respective alloys tabulated in Table IA, IB, IC and ID. Alloys other than those specifically covered herein may be heat treated using all applicable requirements of this specification.


Content Provider
Society of Automotive Engineers [SAE]


Others Also Bought

MIL-H-6875H(2) NOT 1
Heat Treatment Of Steel, Process For (S/S By SAE-Ams-H-6875)
SAE AMS 2759/1E-2009 (SAE AMS2759/1E-2009)
Heat Treatment of Carbon and Low-Alloy Steel Parts Minimum Tensile Strength Below 220 ksi (1517 MPa)
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS