Most recent
ASTM B200-22
Standard Specification for Electrodeposited Coatings of Lead and Lead-Tin Alloys on Steel and Ferrous Alloys
1.1This specification covers the requirements for electrodeposited coatings of lead and lead-tin alloys on steel and ferrous alloys. The coatings of lead-tin alloys are those that range in tin content up to, but not exceeding, 15 mass %. The coatings ranging between 3 and 15 mass % in tin content are known also as "terne" metallic electrodeposits.
1.2This specification does not apply to sheet, strip, or wire in the unfabricated form.
1.3Units - The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4The following precautionary caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Content Provider
ASTM International [astm]
