Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page

 Historical

ISO 2780:2006

Milling cutters with tenon drive - Interchangeability dimensions for cutter arbors - Metric series

ISO 2780:2006 specifies the dimensions for interchangeability between milling cutters with tenon drive and the cutter seating of cutter arbors.

It is applicable only to milling cutters of the metric series.

It gives the interchangeability dimensions for the milling cutters, the cutter seating on the arbor, and the cutter retaining screw on the cutter arbor.

Available for Subscriptions

Content Provider
International Organization for Standardization [iso]

Others Also Bought

ISO 240:1994
Milling cutters - Interchangeability dimensions for cutter arbors or cutter mandrels
Add to cart
ISO 2586:1985
Shell end mills with plain bore and tenon drive - Metric series
Add to cart
Document History
Revises:
Revised By:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2023 © American National Standards Institute (ANSI) All Rights Reserved.