Most recent
ASTM C781-20
Standard Practice for Testing Graphite Materials for Gas-Cooled Nuclear Reactor Components
1.1 This practice covers the application and limitations of test methods for measuring the properties of graphite materials. These properties may be used for the design and evaluation of gas-cooled reactor components.
1.2 The test methods referenced herein are applicable to materials used for replaceable and permanent components as defined in Section 7 and includes fuel elements; removable reflector elements and blocks; permanent side reflector elements and blocks; core support pedestals and elements; control rod, reserve shutdown, and burnable poison compacts; and neutron shield material. Specific aspects with respect to testing of irradiated materials are addressed.
1.3 This practice includes test methods that have been selected from ASTM standards and guides that are specific to the testing of materials listed in 1.2. Comments on individual test methods for graphite components are given in Section 8. The test methods are summarized in Table 1.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Content Provider
ASTM International [astm]
