Most recent
ASTM D1894-24
Standard Test Method for Static and Kinetic Coefficients of Friction of Plastic Film and Sheeting
1.1 This test method covers determination of the coefficients of starting and sliding friction of plastic film and sheeting when sliding over itself or other substances at specified test conditions. The procedure permits the use of a stationary sled with a moving plane, or a moving sled with a stationary plane. Both procedures yield the same coefficients of friction values for a given sample.
Note 1: For the frictional characteristics of plastic films partially wrapped around a cylinder, or capstan, see Test Method G143 under the jurisdiction of ASTM Subcommittee G02.50.
1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.
1.2.1 As an option to this test, measuring coefficient of friction at temperatures other than 23°C is performed by heating/cooling only the plane while the sled is at ambient temperature.
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see the end of 6.5.
Note 2: This test method is not equivalent to ISO 8295–1995, and results cannot be directly compared between the two methods.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM International [astm]