Historical
ASTM D4437-08
Standard Practice for Non-destructive Testing (NDT) for Determining the Integrity of Seams Used in Joining Flexible Polymeric Sheet Geomembranes
1.1 This practice is intended for use as a summary of nondestructive quality control test methods for determining the integrity of seams used in the joining of flexible sheet materials in a geotechnical application. This practice outlines the test procedures available for determining the quality of bonded seams. Any one or combination of the test methods outlined in this practice can be incorporated into a project specification for quality control. These test methods are applicable to manufactured flexible polymeric membrane linings that are scrim reinforced or nonreinforced. This practice is not applicable to destructive testing. For destructive test methods look at other ASTM Standards and Practices.
1.2 The types of seams covered by this practice include the following: Thermally Bonded Seams, Hot Air, Hot Wedge (or Knife), Extrusion, Solvent Bonded Seams, Bodied Solvent Bonded Seams, Adhesive Bonded or Cemented Seams, Taped Seams, Waterproofed Sewn Seams.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. No other units of measurement are included in this standard.
1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM International [astm]