Historical

ASTM D5948-05(2012)

Standard Specification for Molding Compounds, Thermosetting

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 Classification???Molding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).

Resin

Phenolic, cellulose filled

Phenolic, mineral/glass filled

Melamine

Polyester

Diallyl iso-phthalate

Diallyl ortho-phthalate

Silicone

Epoxy


Note 1???There is no equivalent ISO standard.

1.3 Order of Precedence???In the event of a conflict between the text of this specification and the references cited in Section 2 (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

CONTENT PROVIDER
ASTM International [astm]

Included in Packages
This standard is not included in any packages.
Document History
Revises:
Revised By:
Amendments & Corrections
We have no amendments or corrections for this standard.