Most recent
ASTM F3014-14
Standard Test Method for Penetration Testing of Needles Used in Surgical Sutures
1.1 This test method describes the procedure for penetration testing sharp and blunt needles used for the placement of surgical sutures. It only describes the test procedures (Phase 1) and does not define a test medium at this time. Test media will be address in the next phase (Phase 2) of this test method’s evolution.
1.2 This test method applies to straight and curved surgical needles.
1.3 This test method does not intend to address the value of the test with respect to actual conditions of use.
1.4 In this test method, it is assumed the needles used for this test have passed all applicable quality standards and have no physical malformation that would inappropriately influence the test results.
1.5 This test method quantifies the force required for a needle to pass through a medium and its ability to do so multiple times.
1.6 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Content Provider
ASTM International [astm]
