Historical

ASTM F38-00

Standard Test Methods for Creep Relaxation of a Gasket Material

1.1 These test methods provide a means of measuring the amount of creep relaxation of a gasket material at a stated time after a compressive stress has been applied.

1.1.1 Test Method A -Creep relaxation measured by means of a calibrated strain gage on a bolt.

1.1.2 Test Method B -Creep relaxation measured by means of a calibrated bolt with dial indicator.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

CONTENT PROVIDER
ASTM International [astm]

Others Also Bought
Standard Test Methods for Rubber O-Rings
Standard Definitions of Terms Relating to Gaskets
Standard Specification for Rubber Sheet Gaskets
Included in Packages
This standard is not included in any packages.
Document History
Revised By:
Amendments & Corrections
We have no amendments or corrections for this standard.