Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page

 Historical

BS EN 10246-17:2000

Non-destructive testing of steel tubes. Ultrasonic testing of tube ends of seamless and welded steel tubes for the detection of laminar imperfections (British Standard)

This Part of EN 10246 specifies requirements for the full peripheral ultrasonic testing of the ends of seamless and welded tubes for the detection of laminar imperfections. The standard specifies acceptance levels and calibration procedures.  This Part of EN 10246 is applicable to the inspection of welded tubes with an outside diameter greater than 30 mm.  No lower limit of wall thickness is specified but see note in 3.1. European Standard EN 10246 "Non destructive testing of steel tubes" comprises the parts shown in Annex A.

Available for Subscriptions

Content Provider
British Standards Institution [bsi]

Document History
Revised By:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.