Most recent
DIN 6935 Beiblatt 2:2011
Cold bending of flat steel products - Supplement 2: Calculated compensating values
This supplement 2 of DIN 6935 indicates correction values for different bending angles, bending radius and flat rolled steel thicknesses which were calculated on the basis of DIN 6935. The calculation resulted in 4 decimal places after the decimal point , which were rounded off to 2 decimal places and indicated as such in the table.*This standard is the technical revision of the standard which has been published in 2010-01. This revision primarily includes the update of the normative references. This standard provides compensating values for various bending angle and bending radii and flat product thicknesses which have been calculated on the basis of DIN 6935. The calculation was made with4 digits after the comma, the values given in the tables are rounded to 2 digits after the comma. This standard has been prepared by NA 026-00-03 AA "Stanzteile" ("Stamped parts") of the Springs, Stamped Parts and Moulded Parts Standards Committee (NAFS) at DIN, the German Institute for Standardization e. V. For further information about the NAFS, visit us on the Internet under www.nafs.din.de.
- ADD TO ALERT |
- PDF |
Deutsches Institut für Normung [din]