Customer Service:
Mon - Fri: 8:30 am - 6 pm EST

 Most recent

IEC 60404-8-10 Ed. 2.0 b:2009

Magnetic materials - Part 8-10: Specifications for individual materials - Magnetic materials (iron and steel) for use in relays

"IEC 60404-8-10:2009 specifies the general requirements, magnetic properties, geometric characteristics and tolerances as well as inspection procedures for magnetic materials used primarily for relays. This standard applies to pure iron, non-alloyed and alloyed steel and ferritic stainless steel products usually delivered in either the semi-processed or fully-processed state. These materials correspond to classes A, B, C and D.3 of IEC 60404-1. This second edition cancels and replaces the first edition published in 1994 and constitutes a technical revision. The main modifications from the previous edition of the standard are as follows:
- introduction of the ferritic stainless steels and the fully-processed state in the scope of the standard (see Clause 1);
- modification of the designation with the letter R at the beginning and the condition and state at the end (see Clause 5);
- introduction of the new grades R160 and R320 (see Table 2);
- modification of the requirements for the heat treatment of test specimens for semi-processed material (see Subclause 8.3.1);
- indication in Bibliography of standards referred to in this standard as an information. "

Content Provider
International Electrotechnical Commission [iec]

Document History
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.