Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page preview

 Historical

ISO 14405-2:2011

Geometrical product specifications (GPS) - Dimensional tolerancing - Part 2: Dimensions other than linear sizes

ISO 14405-2:2011 illustrates the use of geometrical tolerancing for dimensions that are not linear sizes to avoid the ambiguity that the use of ± tolerances on these dimensions causes. Both linear and angular dimensions, except size of features of size, are covered.

Dimensional tolerancing can be indicated by ± tolerancing or geometrical tolerancing.

The ambiguity caused by using ± tolerances for dimensions other than linear sizes is explained in an informative annex.

Available for Subscriptions

Content Provider
International Organization for Standardization [iso]

Others Also Bought

ISO 14405-1:2010
Geometrical product specifications (GPS) - Dimensional tolerancing - Part 1: Linear sizes
Add to cart
ISO 14405-1:2016
Geometrical product specifications (GPS) - Dimensional tolerancing - Part 1: Linear sizes
Add to cart
ISO 14405-3:2016
Geometrical product specifications (GPS) - Dimensional tolerancing - Part 3: Angular sizes
Add to cart
Document History
Revises:
Revised By:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.