Most recent

ISO 15500-12:2015

Road vehicles - Compressed natural gas (CNG) fuel system components - Part 12: Pressure relief valve (PRV)


ISO 15500-12:2015 specifies tests and requirements for the pressure relief valve (PRV), a compressed natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833.

ISO 15500-12:2015 is applicable to vehicles using natural gas in accordance with ISO 15403-1 (mono-fuel, bi-fuel, or dual-fuel applications). It is not applicable to the following:

a) liquefied natural gas (LNG) fuel system components located upstream of, and including, the vaporizer;

b) fuel containers;

c) stationary gas engines;

d) container mounting hardware;

e) electronic fuel management;

f) refuelling receptacles.

NOTE 1 It is recognized that miscellaneous components not specifically covered herein can be examined to meet the criteria of this part of ISO 15500 and tested according to the appropriate functional tests.

NOTE 2 All references to pressure in this part of ISO 15500 are to be considered gauge pressures unless otherwise specified.

NOTE 3 This part of ISO 15500 is based upon a service pressure for natural gas as a fuel of 20 MPa [200 bar[1]] settled at 15 °C. Other service pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio). For example, a 25 MPa (250 bar) service pressure system will require pressures to be multiplied by 1,25.

[1] 1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2.


CONTENT PROVIDER
International Organization for Standardization [iso]

Others Also Bought
Road vehicles - Compressed natural gas (CNG) fuel system components - Part 2: Performance and general test met ...
Road vehicles - Compressed natural gas (CNG) fuel system components - Part 1: General requirements and definit ...
Road vehicles - Compressed natural gas (CNG) fuel system components - Part 8: Pressure indicator
Document History
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.