Most recent
ISO 228-1:2000
Pipe threads where pressure-tight joints are not made on the threads -- Part 1: Dimensions, tolerances and designation
This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads, intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.
These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces outside the threads, and by interposing an appropriate seal.
CONTENT PROVIDER
International Organization for Standardization [iso]
International Organization for Standardization [iso]