Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page

 Historical

ISO 286-2:1988

ISO system of limits and fits - Part 2 : Tables of standard tolerance grades and limit deviations for holes and shafts

This part gives of the limit deviations for commonly used tolerance classes calculated from the information given in ISO 286-1. It covers values for the upper and the lower deviations which are illustrated by a figure. It tabulates numerical values for basic sizes from 3 mm up to and including 3150 mm. An annex gives a graphical review of tolerance zones.

Available for Subscriptions

Content Provider
International Organization for Standardization [iso]

Others Also Bought

ISO 286-1:1988
ISO system of limits and fits - Part 1 : Bases of tolerances, deviations and fits
Add to cart
ISO 2768-1:1989
General tolerances - Part 1: Tolerances for linear and angular dimensions without individual tolerance indicat ...
Add to cart
ISO 2768-2:1989
General tolerances - Part 2: Geometrical tolerances for features without individual tolerance indications
Add to cart
Document History
Revised By:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
Corrected By:
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.