Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page

 Historical

ISO 294-3:1996

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 3: Small plates

Specifies two two-cavity moulds, the type D1 and D2, for the injection moulding of small plates measuring 60 mm × 60 mm with a preferred thickness of 1 mm (type D1) or 2 mm (type D2) which can be used for a variety of tests. Replaces the second edition of ISO 294.

Content Provider
International Organization for Standardization [iso]

Others Also Bought

ISO 294-2:1996
Plastics - Injection moulding of test specimens of thermoplastic materials - Part 2: Small tensile bars
Add to cart
ISO 294-1:1996
Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding ...
Add to cart
ISO 1133:1997
Plastics - Determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic ...
Call Customer Service
Document History
Revised By:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.