Historical

ISO 3302-1:1996

Rubber - Tolerances for products - Part 1: Dimensional tolerances

This part of ISO 3302 specifies classes of dimensional tolerances, and their values, for moulded, extruded and calendered solid rubber products. The relevant test methods necessary for the establishment of compliance with this International Standard are also specified.

The tolerances are primarily intended for use with vul-canized rubber but may also be

CONTENT PROVIDER
International Organization for Standardization [iso]

Others Also Bought
Classification system for flash
Rubber - Tolerances for products - Part 2: Geometrical tolerances
Rubber - Tolerances for products - Part 2: Geometrical tolerances
Included in Packages
This standard is not included in any packages.
Document History
Revised By:
Amendments & Corrections
Amended By: