Historical

ISO 5951:1993

Hot-rolled steel sheet of higher yield strength with improved formability

Applies to products produced in thicknesses of 1,6 mm and over and widths of 600 mm and over, in coils and cut lengths. Hot-rolled sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet. Specifies conditions of manufacture (steelmaking, chemical composition, chemical analysis, weldability, application, mechanical properties, surface condition), dimensional tolerances, sampling, mechanical property test (tensile test, impact test), retests, resubmission, workmanship, inspection and acceptance, coil size, information to be supplied by the purchaser. Annex A gives information on fabricability.

CONTENT PROVIDER
International Organization for Standardization [iso]

Included in Packages
This standard is not included in any packages.
Document History
Revised By:
Amendments & Corrections
We have no amendments or corrections for this standard.