Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page preview

 Most recent

ISO 887:2000

Plain washers for metric bolts, screws and nuts for general purposes -- General plan

This International Standard specifies the full range of the nominal dimensions of product-grade-A and -C plain washers for general-purpose bolts, screws and nuts of nominal thread diameters ranging from 1 mm to 150 mm inclusive.

This International Standard is not applicable to washers for screw and washer assemblies in relation to hole diameters and thicknesses.

Information on the use of plain washers is given in annex A.

Available for Subscriptions

Content Provider
International Organization for Standardization [iso]

Others Also Bought

ISO 3269:2000
Fasteners -- Acceptance inspection
Add to cart
ISO 1940-1:2003
Mechanical vibration -- Balance quality requirements for rotors in a constant (rigid) state -- Part 1: Specification ...
Add to cart
IPC J-STD-001F+Amd1-2016
Requirements for Soldered Electrical and Electronic Assemblies with Amendment 1
Add to cart
Document History
Revises:
  • ISO 887:1983
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
Corrected By:
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.