Most recent
ONORM EN ISO 20430:2024
Plastics and rubber machines - Injection moulding machines - Safety requirements (ISO 20430:2020)
This document specifies the essential safety requirements for the design and construction of injection molding machines for processing plastic and/or rubber and provides information for their safe use. This document only applies to injection molding machines with hydraulic and/or electric drives for the movement of the platen. This document addresses all significant hazards, hazardous situations or hazardous events applicable to injection molding machines when used as intended and under conditions of misuse that are reasonably foreseeable by the manufacturer during the life cycle of the machine (see ISO 12100:2010, 5.4) ( see Appendix A). The following are not covered: - Machines in which the clamping unit can only be operated by the physical strength of the operator; - Machines where the hydraulic lifting device can only be operated manually; - injection blow molding machines; - machines for reaction casting; - compression molding and transfer molding; - direct soling machines, sole and shoe part molding machines, shoe and boot molding machines; - Construction of a suction system; - Design and construction of the tool.
- ADD TO ALERT |
- PDF |
Austrian Standards Institute [on]