Most recent

ONORM EN ISO 8742:1998

Grooved pins - One-third-length centre grooved (ISO 8742:1997) (Austrian Standard)

This International Standard specifies the characteristics of one-third-length centre grooved pins made of steel or austenitic stainless steel which have three equally spaced grooves impressed longitudinally on their exterior surface, with nominal diameter, d1, from 1,5 mm to 25 mm inclusive.

The displaced material to each side of the grooves forming an expanded diameter, d2, which is larger than the nominal diameter d1 will cause a non-positive locking fit when these grooved pins are forced into a drilled hole equal to the nominal diameter d1 (see clause 4).

CONTENT PROVIDER
Austrian Standards Institute [on]

Others Also Bought
Drive Type Fastenings without Taper Action; Woodruff Keys, Dimensions and Application
Drive Type Fastenings without Taper Action; Parallel Keys, Keyways, Deep Pattern
Grooved Pins, Half Length Grooved with Gorge (Foreign Standard)
Included in Packages
This standard is not included in any packages.
Document History
We have no document history for this standard.
Amendments & Corrections
We have no amendments or corrections for this standard.