Historical
AS 2129-2000
Flanges for pipes, valves and fittings (FOREIGN STANDARD)
Specifies requirements and dimensions for circular, plate blank, boss, integrally cast or forged and welding-neck type flanges or nominal sizes DN 15 to DN 3000 and their bolting for use on pipes, valves and fittings and other pressure-retaining equipment containing fluid at pressures up to 19300 kPa and at temperatures in the range -200°C to +525°C. Flanges in carbon steel, carbon-manganese steel, low-alloy steel, stainless steel, grey iron, malleable iron, ductile cast iron or copper alloy, together with relevant material specifications are included. This Standard is applicable to flanges for water, steam, compressed air, chemical and petroleum plants, hydraulic piping and where other Standards require compliance with this Standard. Recommendations on the selection of bolting and method of making flanged joints are included. This Standard is not intended to apply to flanges for water or waste water covered by AS 4087.
Standards Australia [sai]