UL 2202 Ed. 3-2022 (2026)

DC Charging Equipment for Electric Vehicles - Published Date: July 21, 2026

This revision of UL 2202 dated July 21, 2026 is an editorial update to remove the ANCE logo and approval from the title page and and ANCE references from the Preface. No technical changes have been made. As noted in the Commitment for Amendments statement located on the back side of the title page, ULSE and CSA are committed to updating this harmonized standard jointly. However, the revisions dated July 21, 2026 will not be jointly issued by ULSE and CSA as these revision pages address removal of the ANCE logo from the title page and Preface. While ANCE continues to participate in the technical development of this trinational standard, the ANCE logo has been removed from the title page and Preface as standards cannot be formally published in Mexico at this time. 1 Scope 1.1 These requirements apply to DC conductive charging equipment intended to be supplied with a maximum input voltage of 1000 V ac or 1500 V dc, for recharging the propulsion batteries in over-the-road electric vehicles (EV). DC charging equipment for EV installations are intended for either: a) Dry location only, or b) Dry, wet, and damp location. Equipment is intended to be installed in accordance with the Installation Codes in Annex A, Ref. No. 1. 1.2 The output of the DC charging equipment for EV shall not exceed 1500 V dc. 1.3 For the purposes of this Standard, the term "electric vehicle", designated throughout by the initials "EV", is considered to cover electric vehicles, hybrid electric vehicles, and plug-in versions of these vehicles. 1.4 DC charging equipment for EV that is not a complete assembly and depends upon installation in an end product for compliance with the requirements in this Standard is investigated under the requirements of this Standard and the standard for the end product. 1.5 These requirements do not cover battery chargers covered by Annex A, Ref. Nos. 2 and 3. 1.6 These requirements do not cover on-board chargers. 1.7 These requirements do not cover electric vehicle supply equipment covered by Annex A, Ref. No. 4. 1.8 These requirements do not cover DC charging equipment for EV intended to be used in hazardous locations, such as near fuel dispensing stations.