.jpg)
Historical
ANSI/AGMA 2008-D11 (R2016)
Assembling Bevel Gears
Information pertaining to recommended practice in the assembling of bevel gears is not new in the published literature of the American Gear Manufacturers Association. In 1927, the Recommended Practice of the American Gear Manufacturers Association of Adjustment of Bevel Gears in Assembly was adopted and published. This practice was revised in 1940 by the Bevel Gear Committee, but no further revision was undertaken until 1967. Since the satisfactory performance of bevel gears is closely related to proper installation, it was decided by the Bevel Gearing Committee that it was important to maintain information on this subject in the literature of the Association. This manual brings up to date and reflects the present thinking on the information given in the original practice. This manual was prepared for the assembly personnel in the factory and for the service personnel in the field. Each definition, explanation, and instruction is directed toward the physical appearance of the gears as they are inspected and assembled. The definitions are simple. The explanations are thorough. Each section devoted to the tooth contact pattern of a particular type of gear is intended to be complete in itself for use as a separate shop manual if desired. For this reason, when the manual is read in its entirety, these sections seem repetitious. In contrast, the sections devoted to angular gears are brief and general. The committee concluded that each angular configuration requires separate treatment, and that a complete coverage of all of the possible combinations would be impractical if at all possible. The first draft of AGMA 331.01 was prepared by the Bevel Gearing Committee in October, 1967. It was approved by the AGMA membership and became an official AGMA manual as of August 2. 1969. The manual was reaffirmed in 1976. ANSI/AGMA 2008-B90 is a revision of AGMA 331.01. It was approved by the AGMA membership on November 10, 1989, and as an American National Standard on May 4, 1990. An errata was issued in June, 1995 that changed the denominator of the equation for "Transverse Backlash, Bt” in figure 7-1, to reflect the product of the cosine terms, rather than their difference. ANSI/AGMA 2008-C01 was a correction of ANSI/AGMA 2008-B90. In 2000 an errata revision of clauses 7.2, 8.3.1 and 8.3.2 was balloted. This was approved by the AGMA membership in June 2001 and as an American National Standard on November 20, 2001. ANSI/AGMA 2008-D11 is an update to ANSI/AGMA 2008-C01, converting to metric. Backlash recommendations were revised to reflect current accuracy standards. An Annex was added to detail the procedures used in contact pattern checking. The first draft of ANSI/AGMA 2008-D11 was made in April, 2008. It was approved by the AGMA membership in April, 2011. It was approved as an American National Standard on August 29, 2011.
Content Provider
American Gear Manufacturers Association [agma]
