Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page

 Most recent

ASSE 1056-2013 (R2021)

Performance Requirements for Spill Resistant Vacuum Breaker Assemblies

This standard applies only to those assemblies classified as spill resistant vacuum breaker assemblies (SVB). These assemblies are designed for installation in water systems that are normally under continuous pressure conditions. Spill resistant vacuum breaker assemblies are installed in the water supply lines to prevent the backflow of non-potable material into the potable water supply caused by backsiphonage only. They are not for use in any system where backpressure is applied to the assembly. When the system is pressurized, the air inlet valve closes to prevent a flow through the check valve and to eliminate vent spillage.

Available for Subscriptions

Content Provider
American Society of Sanitary Engineering [asse-sanitary]

Document History
Revises:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.