Most recent
ASTM C1352/C1352M-21
Standard Test Method for Flexural Modulus of Elasticity of Dimension Stone
1.1This test method covers the procedure for determining the flexural modulus of elasticity of stone by using a simple beam with quarter-point loading.
1.2Stone tests may be made with load applied perpendicular to the bedding plane or rift and with load applied parallel to the bedding plane or rift.
1.3Stone tests may be made for wet and dry specimen conditions.
1.4The specifier of the test shall determine which conditions shall be used.
1.5The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Content Provider
ASTM International [astm]
