Most recent
ASTM D7293-19
Standard Specification for Extruded and Compression-Molded Shapes Made from Polyetherimide (PEI)
1.1 This specification covers requirements and test methods for the dimensions, workmanship, and the properties of extruded and compression-molded sheet, plate, rod and tubular bar manufactured from polyetherimide (PEI) resins.
1.2 The properties included in this specification are those required for the compositions covered. It is possible that other requirements will be necessary to identify particular characteristics important to specialized applications. These shall be specified by using the suffixes as given in Section 5.
1.3 This specification does not allow for the use of recycled plastics (as defined in Guide D7209).
1.4 The values stated in English units are regarded as standard in all property and dimensional tables. For reference purposes, SI units are also included in Table 1 and Table S-PEI.
1.5 The following safety hazards caveat pertains only to the test method or test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: There is no known ISO equivalent to this standard.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Content Provider
ASTM International [astm]
