Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page

 Historical

ISO 294-1:1996

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens

Contains the general principles to be followed for the preparation of injection moulding test specimens of thermoplastics and gives details of mould design for preparing multipurpose test specimens as specified in ISO 3167 and tensile bars. Replaces the second edition of ISO 294.

Available for Subscriptions

Content Provider
International Organization for Standardization [iso]

Others Also Bought

ISO 294-1/Amd1:2001
Amendment 1
Add to cart
ISO 294-1/Amd2:2005
Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding ...
Add to cart
ISO 294-2:1996
Plastics - Injection moulding of test specimens of thermoplastic materials - Part 2: Small tensile bars
Add to cart
Document History
Revised By:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
Amended By:
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.