Historical

ASTM A554-10

Standard Specification for Welded Stainless Steel Mechanical Tubing

1.1 This specification covers welded stainless steel tubing for mechanical applications where appearance, mechanical properties, or corrosion resistance is needed. The grades covered are listed in Table 1.

1.2 This specification covers as-welded or cold-reduced mechanical tubing in sizes to 16 in. (406.4 mm) outside dimension, and in wall thicknesses 0.020 in. (0.51 mm) and over.

1.3 Tubes shall be furnished in one of the following shapes as specified by the purchaser: round, square, rectangular, or special.

1.4 Supplementary requirements of an optional nature are provided and when desired shall be so stated in the order.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

CONTENT PROVIDER
ASTM International [astm]

Others Also Bought
Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels ...
Steel, Corrosion and Heat Resistant, Seamless or Welded Hydraulic Tubing 18.5Cr 10.5Ni 0.55Ti (321) Solution Heat ...
Steel, Corrosion and Heat Resistant, Seamless Tubing 9.0Mn 20Cr 6.5Ni 0.28N Solution Heat Treated
Included in Packages
This standard is not included in any packages.
Document History
Revises:
Revised By:
Amendments & Corrections
We have no amendments or corrections for this standard.