Historical
ASTM D1301-91(2008)
Standard Test Methods for Chemical Analysis of White Lead Pigments
1.1 These test methods cover procedures for the chemical analysis of basic carbonate white lead and basic sulfate white lead.
Note 1—If it is necessary to separate these pigments from others, refer to Practice D 215
1.2 The analytical procedures appear in the following order:
| Section | |
| Preparation of Sample | 6 |
| Basic Carbonate White Lead: | |
| Small Amounts of Iron | 7 |
| Total Lead | 8 |
| Moisture and Other Volatile Matter | 9 |
| Carbon Dioxide (Evolution Method) | 10 |
| Carbon Dioxide and Combined Water (Combustion Method) | 11 |
| Lead Carbonate | 12 |
| Total Matter Insoluble in Acetic Acid | 13 |
| Total Matter Insoluble in Acid Ammonium Acetate | 14 |
| Total Impurities Other Than Moisture | 15 |
| Coarse Particles | 16 |
| Basic Sulfate White Lead: | |
| Small Amounts of Iron | 17 |
| Total Lead | |
| Moisture and Other Volatile Matter | 19 |
| Total Sulfate | 20 |
| Zinc Oxide | 21 |
| Basic Lead Oxide | 22 |
| Total Impurities | 23 |
| Coarse Particles | 24 |
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
CONTENT PROVIDER
ASTM International [astm]
ASTM International [astm]