Most recent
ASTM F7-95(2021)
Standard Specification for Aluminum Oxide Powder
1.1 This specification covers aluminum oxide (alumina) powder in two classes of particle size, two chemical grades, and two levels of acidity, for use as an insulating coating or as an ingredient of ceramic mixtures for components of electronic devices as follows:
1.1.1 Particle Sizes:
1.1.1.1 Class A—Particle size No. 500 nominal mesh (nominal average particle size = 24.3 μm).
1.1.1.2 Class B—Particle size No. 900 nominal mesh (nominal average particle size = 1.7 μm).
1.1.2 Chemical Grades—Grades 1 and 2 as specified under chemical requirements in Section 3.
1.1.3 Acidity Levels: pH (acid) 4.5 to 6.5 and pH (neutral) 6.5 to 7.5.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The following safety hazards caveat pertains only to the test methods in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM International [astm]