DIN 1469:2011

Grooved pins, half length grooved with gorge (Foreign Standard)

This standard applies for grooved pins, half length grooved with gorge, which are used for the collet of snap-ring, retaining washers or springs. These grooved pins have a nominal diameter of d<(Index)1> of 1,5 mm to 25 mm, and are shaped as profil A (with a groove for snap-rings according to DIN 471), profil B (with a groove for retaining washers according to DIN 6799) and profil C (with a rounded groove).*This document has been prepared by the Fasteners Standards Committee (FMV), Working Committee NA 067-00-09 AA "Verbindungselemente ohne Gewinde" ("Fasteners without thread"). This standard applies for grooved pins, half length grooved with gorge (frictional and interlocking connection), which are used for the collet of snap-ring, retaining washers, springs or similar, whereby the pin is firmly fixed in the locating bore. These grooved pins have nominal diameters of d<(Index)1> of 1,5 mm to 25 mm, and are shaped as profil A (with a groove for snap-rings according to DIN 471), profil B (with a groove for retaining washers according to DIN 6799) and profil C (with a rounded groove).