Historical

IEST-RP-CC034.4

HEPA and ULPA Filter Leak Tests


This Recommended Practice (RP) covers definitions, equipment, and procedures for leak testing high-efficiency particulate air (HEPA) filters and ultralow-penetration air (ULPA) filters in the factory as they are produced, at the job site before they are installed, and after they are installed in cleanrooms and in unidirectional-flow, clean-air de-vices. When used in conjunction with other RPs, including IEST-RP-CC001, IEST-RP-CC002, IEST-RP-CC006, IEST-RP-CC007, IEST-RP-CC021, IEST-RP-CC028, and IEST-RP-CC036, this RP may be used to define the basis of an agreement between the customer and supplier in the specification and procurement of HEPA and ULPA filters, and in the testing of these filters in unidirectional-flow, clean-air devices and cleanrooms. This RP also includes procedures for measuring the uniformity of the aerosol challenge approaching the filter under test. Although the scanning methods in the factory and in situ (in the field) appear similar, they are not identical, mainly due to increased variability for in-situ testing. In this revision of the RP, the recommended procedures for factory and in-situ testing are separated for ease of use. In factory and in-situ testing, if a leak is detected while scanning a filter, it is recommended that the magnitude of the leak be quantified with the scanning probe stationary over the detected leak.


CONTENT PROVIDER
Institute of Environmental Sciences and Technology [iest]

Others Also Bought
Testing Cleanrooms
HEPA and ULPA Filters
Calibration Procedures and Guidelines for Select Equipment used in Testing Cleanrooms and Other Controlled Env ...
Included in Packages
This standard is not included in any packages.
Document History
Revised By:
Amendments & Corrections
We have no amendments or corrections for this standard.