Customer Service:
Mon - Fri: 8:30 am - 6 pm EST
Back
Standards PDF Cover Page

 Historical

ISO 898-2:1992

Mechanical properties of fasteners - Part 2: Nuts with specified proof load values - Coarse thread

Applies to nuts with nominal thread diameters up to and including 39 mm, specific mechanical requirements, widths across flats as specified in ISO 272, nominal heights greater than or equal to half the nominal diameter of the internal thread, made of carbon steel or low alloy steel. Does not apply to nuts requiring special properties (such as weldability, corrosion resistance, etc.). Values apply when tests are made at room temperature.

Available for Subscriptions

Content Provider
International Organization for Standardization [iso]

Others Also Bought

ISO 898-1:1999
Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs
Add to cart
ISO 898-7:1992
Mechanical properties of fasteners - Part 7: Torsional test and minimum torques for bolts and screws with nominal ...
Add to cart
ISO 898-6:1994
Mechanical properties of fasteners - Part 6: Nuts with specified proof load values - Fine pitch thread
Add to cart
Document History
Revised By:
Included in Packages
This standard is not included in any packages.
Amendments & Corrections
We have no amendments or corrections for this standard.
ANSI Logo

As the voice of the U.S. standards and conformity assessment system, the American National Standards Institute (ANSI) empowers its members and constituents to strengthen the U.S. marketplace position in the global economy while helping to assure the safety and health of consumers and the protection of the environment.

Useful Links
CUSTOMER SERVICE
NEW YORK OFFICE
ANSI HEADQUARTERS
2024 © American National Standards Institute (ANSI) All Rights Reserved.